The application of the automatic manure scraper in the chicken house can greatly reduce the labor intensity, make the chicken house have a good air environment, give the chicken a good living space, and reduce diseases.

To use an automatic manure scraper, you must first build a trench. The trench is generally designed to be shallow on one side and deep on the other side. The deep side should be where the manure is discharged and the host is fixed. The shallow end is convenient for flushing with water when cleaning, and it is also convenient for the main unit to be hidden underground.

The host installation should dig a pit with a length of one meter in width and a depth of 70 cm. Then pour it with concrete. This plane should be lower than the bottom of the trench, so that it is easy to install the host.

When installing the corner wheel, please refer to the installation drawing. Note that the side of the wheel groove where the rope is wound is the center, not the center of the shaft of the steering wheel. If the center is wrong, the manure board will be unstable when scraping.

When winding the rope, one end of the rope should be wrapped around the two rope reels of the main unit. Then wind the steering wheel. Finally, it can be buckled to death on a scraping board.

There should be two people on the tightrope. One person turns the switch, the other person loops the rope over the manure scraper frame, and then puts the rope head on the shaft of the steering wheel, and then one person pulls the rope, the other turns on the switch, and the host pulls the rope tight.

The above is the installation method of the shared manure scraper. If you have any questions or want to buy, you can find a chicken farming equipment supplier, and we will be at your service at any time.